Touch switches are available in three versions

The sensor wall dimmer (light regulator) is designed to control one load line with the possibility of smooth adjustment of the light brightness level. Control is carried out both with the help of a touch panel and with the help of a remote control. The dimmer has a built-in "memory of the last adjusted brightness level" function. When you turn it on again, the brightness of the lighting is automatically set to the last, adjusted level.

Allowed types of lamps: incandescent lamps, energy-saving, halogen lamps (220 V, and low-voltage transformer 12 V and 24 V), fluorescent lamps (with electronic ballast), LED lamps and LED strips.

Attention! With LED lamps, energy-saving and tapes, as well as with fluorescent lamps with a total power of up to 18 W, the switches may not work correctly (in the off state, the lamps may flash). This problem can be solved by parallel installation of the LED Adapter. Eliminates the problem of flickering of these lamps and spontaneous switching on of switches with insufficient load on the line (less than 5 W). On one line, regardless of the number of light sources (lamps), only one adapter is connected in parallel with one of the light sources (lamps).

Remote control is carried out via a radio channel, which allows you to control the switch from any room within the range of the remote control.
This feature makes the control of lighting devices much more convenient, in contrast to systems with IR control, which operate only in the direct line of sight of the switch and the remote control.

For ease of use in the dark, the switch has an LED backlight with an on / off status indication mode. In the off state, the sensor zone is illuminated in blue, when the light is turned on, the sensor zone begins to be illuminated in red. Also, in these models, the "smooth on/off" system is implemented, which significantly increases the service life of the lamps.

Touch control is carried out using built-in modern capacitive sensors, which allows the switch to respond clearly to any touches to the touch zone.

The switch has the function of automatic disconnection in the event of a circuit break. If the light bulbs in the load circuit burn out or the automatic protection switch (the so-called circuit breaker) is activated during an overload in the circuit, the switch switches to the OFF state.

The front panel of the switches is made of OptiWite optical glass, thanks to which the switch panel is not only resistant to scratches, but also extremely easy to maintain.

Installing and connecting the switch does not require any changes to the wiring, because it is connected to the circuit according to the standard circuit. The switch is installed in a round mounting box for hidden installation with a diameter of 65-70 mm and a depth of 50 mm with a distance of 60 mm between the centers for the fastening screws.

Outlets