Quantity
|
Out of stock
|
||
|
Touch remote control panel for Livolo switches. It can connect and control multiple switches simultaneously, allowing customization of non-standard lighting scenes to your preference. Supports room (zone) switching, dimming, and the ability to program six lighting scenarios.
- Capability to connect up to 27 switches.
- Capability to connect up to 27 dimmers.
- Control with one remote in three different rooms.
- Ability to create 6 lighting scenarios.
Programming the VL-RMT-04 remote
- Hold the switch sensor for 5 seconds.
- Release after the sound signal.
- Press a button on the remote (for example, button 1).
- A sound signal confirms successful synchronization.
Note: To cancel synchronization, hold the button for 10 seconds. A double sound signal indicates cancellation of synchronization.
Features
- To ensure proper operation of the touch buttons on the remote, they should not be pressed more frequently than once every 2 seconds.
- The remote has 9 touch buttons for controlling 27 lighting zones, with the ability to program up to 6 scenarios and control 27 dimmers.
- Control of dimmers is only possible after programming. Long pressing the button adjusts the brightness of the lamp connected to the dimmer.
- For convenient lighting control, the remote is divided into 3 zones (rooms). Corresponding buttons are used to switch between zones (rooms).
- The remote will automatically turn on when touched. If no button is pressed on the remote for 20 seconds, it will automatically turn off.
Scenarios
The remote has two buttons for creating scenarios I and II.
The scenario button memorizes the switch's operating mode, whether it is on or off at the time of programming. It also memorizes the brightness of the lamp connected to the dimmer.
To create a scenario, program the switches needed for the scenario using the scenario button I or II. To do this, press and hold the switch sensor for 5 seconds after the sound signal, and with a second touch, set the required switch operating mode (on/off) or brightness of the lamp (for the dimmer). Then, within 5 seconds, press the scenario button for one second. Repeat the procedure for all switches involved in your scenario.