A convenient remote control designed for controlling LIVOLO electric curtain motors, roller blinds, and motorized curtain tracks. The remote supports up to 63 individual channels, allowing multiple drives to be controlled from a single device. The digital display shows the selected channel, while the AL mode is designed for group control of all programmed channels.

The remote has separate buttons for moving the drive in both directions and stopping it. The channel selection buttons allow you to quickly switch between different curtains, roller blinds, or curtain tracks. On the back of the remote there is a Study button used to pair the remote with a LIVOLO motorized curtain track or roller blind motor. A wall-mounted holder is included for convenient storage of the remote.

Key advantages

• 63 control channels — one remote can control a large number of drives.
• AL group control — simultaneous control of a programmed group.
• Digital display showing the active channel number.
• Separate open / stop / close buttons.
• Easy programming and pairing with the receiver.
• Option to hide unused channels.
• Wall-mounted remote holder.
• Powered by two standard batteries.

Button functions

▲ Up — starts the motor in one direction. For a motorized curtain track, this is typically used to open or close the curtain depending on the configuration and motor installation direction.

■ Stop — stops the motor.

▼ Down — starts the motor in the opposite direction.

◀ / ▶ — selects the required channel. No command is sent to the motor while switching between channels.

Study — a button on the back of the remote used to pair the remote with a motorized curtain track or roller blind motor.

Digital display — shows the number of the selected channel. The AL indication means group control mode.

Operating instructions

Selecting and controlling a drive

1. Use the ◀ / ▶ buttons to select the required channel number.
2. Press ▲ to run the motor in one direction.
3. Press ▼ to run the motor in the opposite direction.
4. Press Stop to stop the drive.
5. For group control, select AL mode on the display.

Pairing the remote with the receiver

1. Press and hold the Study programming button on the receiver/motor for approximately 3 seconds.
2. When the indicator lights up, the receiver enters pairing mode.
3. Use the ◀ / ▶ buttons on the remote to select the channel to which you want to pair the drive.
4. Press the Study button on the back of the remote.
5. The receiver indicator will turn off, confirming that pairing has been completed successfully.
6. Check operation using the ▲ / Stop / ▼ buttons.
7. Repeat the procedure to pair other drives with other channels.

How to hide unused channels

The remote supports 63 channels, but unused channels can be hidden for easier operation.

1. Press and hold the ◀ and ▶ buttons simultaneously for approximately 5 seconds.
2. Wait until the display indication starts flashing slowly — the remote will enter channel setup mode.
3. Use the ◀ / ▶ buttons to select the required number of available channels.
4. Press the Study button on the back of the remote.
5. The remote will then switch only between the specified number of channels.

If necessary, the number of active channels can be changed again by repeating the same procedure.