LIVOLO two-button wireless remote control is designed for remote control of compatible LIVOLO touch switches. It allows you to turn lighting on and off without installing additional control wiring.

The remote supports two operating modes: via a gateway with control and automation settings in the LIVOLO HOME app, or through direct pairing of the remote with a compatible switch. Button presses are confirmed by a blue LED indicator. The remote is powered by a standard CR2032 3 V battery.

Key advantages

• 2 control buttons;
• wireless control of compatible LIVOLO switches;
• two connection options: via a gateway or directly to the switch;
• automation support via LIVOLO HOME when operating through a gateway;
• blue LED indicator;
• compact housing measuring 56×32×14.3 mm;
• powered by a CR2032 battery;
• manufacturer-rated battery life of up to 3 years;
• housing made of flame-retardant material.

Operating instructions

1. Installing the battery

Before first use, install a CR2032 3 V battery in the remote. Press a button — the blue indicator at the top of the remote should light up.

2. Connecting via a LIVOLO gateway

Before setup, the gateway must already be added to the system.

1. Open the LIVOLO HOME app.
2. Tap «+» in the upper-right corner.
3. Go to Remotes → Button Remote Controller.
4. Select the required gateway.
5. Follow the instructions in the app to complete pairing.
6. To create an automation, open the Automation section and assign the required action to the remote control button.

Removing the remote from the gateway: in the app, open Button Remote Controllers, tap the «…» menu in the upper-right corner, and select Delete.

3. Direct pairing with a switch

The remote can also operate directly with a compatible switch without using a gateway.

1. Press and hold the button on the switch for approximately 5 seconds.
2. Release the button after the audible signal.
3. Press the corresponding button on the remote. According to the manufacturer's instructions, pairing may require a single, double, or triple press depending on the required command.
4. One audible signal from the switch confirms successful pairing.

4. Unpairing the remote

To remove all paired remote controls, press and hold the switch button for approximately 10 seconds.

To unpair a specific remote command, enter the switch setup mode by holding the button for approximately 5 seconds, then perform the corresponding button press on the remote. Two audible signals confirm successful unpairing.