The pass-through switch function is activated only after synchronization. This means that a synchronization procedure must be performed before the pass-through switches start operating in pass-through mode. Without this, they will work as ordinary switches, without the possibility of activating the passage mode.

Livolo through switches are not compatible with switches from other manufacturers. This is important to consider when choosing equipment for your lighting control system.

The synchronization procedure includes the following steps:

  1. Touch the main switch sensor and hold your finger until you hear a beep. This usually takes about 4-5 seconds. After that, move away from the sensor zone.

  2. Next, touch the auxiliary switch sensor to sync. This step will ensure communication between the main and auxiliary switches.

Reset synchronization:

  1. Touch the main switch sensor and hold it until you hear a second beep. This usually takes about 10 seconds.

  2. After receiving the second beep, the synchronization will be reset and the switches will return to their original unlinked state.